Wideband Power Amplifier Behavioral Modeling Using an Amplitude Conditioned LSTM

Accurate physical-layer modeling is increasingly essential for reliable ultra-wideband operation and capacity optimization, especially under the intensified inter-channel stimulated Raman scattering (ISRS) effect. This paper proposes the link-adaptive digital twin (LA-DT) for hybrid-amplified ultra-wideband links to overcome the generalization and speed limitations of existing methods, achieving accurate modeling and robust generalized signal-to-noise ratio (GSNR) estimation across diverse links. First, to address EDFA heterogeneity, the GSNR modeling task is decomposed into three key power predictions: ASE, NLI, and signal powers before EDFA entry. Second, to enhance cross-scenario generalization, three dedicated DT models are developed using a novel neural architecture with linear modulation layers (LMLs). Third, for rapid adaptation to unseen scenarios with limited data, three domain discriminators guide few-shot fine-tuning of the LMLs. Fourth, the LA-DT explicitly accounts for Raman amplifier (RA) insertion loss, improving practical deployment reliability. Results across 35 scenarios show that LA-DT reduces RMSE for NLI, ASE, and signal power predictions to 0.151, 0.111, and 0.113 dBm with improvements of 56.0%, 58.4%, and 52.7% over the baseline,and achieves an average GSNR estimation RMSE of 0.114 dBm (55.8% improvement). For 12 unseen scenarios, the LA-DT maintains high accuracy through few-shot fine-tuning with only 20 samples per scenario, achieving an average GSNR RMSE of 0.159 dB and demonstrating strong adaptability and robustness.

Power amplifier (PA) nonlinearity and memory effects significantly limit the spectral compliance, reliability, and energy efficiency of communication systems. To address this, we propose a transfer-learning-enabled, fully digital transceiver-cooperative method for amplitude-phase-time block modulation (APTBM)-based nonlinear single-carrier transmission under adjacent channel leakage ratio (ACLR) constraints. At the transmitter, iterative clipping and filtering (ICAF) and static digital pre-distortion (SDPD) act jointly to reduce signal peaks and suppress spectral regrowth without requiring wideband feedback. At the receiver, the inherent amplitude-phase constraints of APTBM provide weakly supervised prior knowledge for offline inverse-model pretraining, which is followed by the online few-shot adaptation of a lightweight digital post-distortion (DPoD) network. Subsequently, a cascaded DPoD and clipping-noise cancellation scheme systematically compensates for residual distortions induced by both the PA and ICAF. Simulation and measurement results demonstrate reliable transmission at an input back-off of approximately 2 dB under a 30-dBc ACLR constraint. Furthermore, the proposed DPoD approach significantly reduces online training time and computational overhead, delivering a performance gain of over 2 dB compared to conventional learning-based DPoD schemes.

This paper presents a deep learning-assisted methodology for the inverse synthesis of a compact, wideband inverted Doherty power amplifier (PA). Convolutional neural networks (CNNs) and genetic algorithms (GAs) are jointly employed to generate pixelated Doherty combiner networks that integrate load modulation, impedance matching, power combining, and phase compensation into a single structure. As a proof of concept, we design and fabricate a GaN HEMT Doherty PA with a pixelated output combiner. The prototype achieves a measured peak drain efficiency of 51%-63% and a 6-dB back-off efficiency of 48%-54% over 1.9-2.5 GHz. Within the same frequency range, the measured output power is 44+/-0.3 dBm. Furthermore, with digital predistortion (DPD) applied, the prototype circuit demonstrates an adjacent channel leakage ratio (ACLR) better than -53.2 dBc.