Modeling and Control of a Pneumatic Morphing Soft Quadrotor based on the SOFA Framework for Dynamic Soft Robotic Simulation

Animals coordinate their movements through distributed neural circuits, but soft robots still typically depend on external, centralized electronics for control. Building soft robots that operate without centralized electronic controllers while remaining responsive to their environment remains a frontier challenge in soft robotics. In this work we introduce a soft-robot control architecture inspired by leaky integrate-and-fire models of biological neural circuits. The Pneumatic neuron (Pneu-ron) is a soft actuator that unifies energy conversion, logic, and actuation in one component. Each module combines a low-boiling-point fluid (LBF), a heater, and a mechanical switch into a self-excitable unit. Boiling the LBF inflates the module and triggers excitation and inhibition of adjacent modules in a process we call "inflate-and-fire". When interconnected into excitatory-inhibitory rings, Pneu-rons generate stable, sequential oscillations whose frequency emerges from the material dynamics and environmental conditions. By harnessing the inflation of Pneu-rons for actuation these networks can drive oscillatory locomotion of soft robots. Pneu-ron networks sustain oscillation under mechanical load and thermal variations, adapting through material physics rather than computation. Dynamical modeling of these networks reveals a dimensionless bifurcation diagram that dictates the network's oscillatory behavior. Encoding logic and actuation into material-level modules presents a new avenue for adaptive, electronics controller-free, soft robots.

Continuum soft robots are inherently underactuated and subject to intrinsic input constraints, making dynamic control particularly challenging, especially in hybrid rigid-soft robots. While most existing methods focus on quasi-static behaviors, dynamic tasks such as swing-up require accurate exploitation of continuum dynamics. This has led to studies on simple low-order template systems that often fail to capture the complexity of real continuum deformations. Model-based optimal control offers a systematic solution; however, its application to rigid-soft robots is often limited by the computational cost and inaccuracy of numerical differentiation for high-dimensional models. Building on recent advances in the Geometric Variable Strain model that enable analytical derivatives, this work investigates three optimal control strategies for underactuated soft systems -- Direct Collocation, Differential Dynamic Programming, and Nonlinear Model Predictive Control -- to perform dynamic swing-up tasks. To address stiff continuum dynamics and constrained actuation, implicit integration schemes and warm-start strategies are employed to improve numerical robustness and computational efficiency. The methods are evaluated in simulation on three Rigid-Soft and high-order soft benchmark systems -- the Soft Cart-Pole, the Soft Pendubot, and the Soft Furuta Pendulum -- highlighting their performance and computational trade-offs.

In this paper, we design feedback control laws for soft robots modelled using the Cosserat rod, which is spatially discretised using the Piecewise Constant Strain (PCS) approach. The PCS approach transforms the nonlinear PDEs describing the Cosserat rod to a system of nonlinear ODEs. This simplification results in a model describing soft robots which is similar to the serial rigid-link manipulators. We design feedback control laws for the quasi-static PCS model by using external wrenches as control inputs. The control laws are designed based on state-feedback linearisation in strain and task spaces. An extensive set of numerical results demonstrates the performance of the control laws for end-effector trajectory tracking and shape control of soft robots.