This study proposes a reconfigurable rocker-bogie mechanism that achieves efficient turning motion with a small number of actuators while maintaining high step-climbing capability. By installing motors at the bogie joints and actively swinging up and down bogies, the system enables switching between four-wheel and six-wheel configurations. Omnidirectional wheels are mounted on the rear ends of the rockers, allowing smooth turning in the four-wheel configuration based on a differential-drive model. Experimental evaluation using a prototype robot demonstrated that the proposed mechanism achieves zero-radius turning at a speed more than five times that of a conventional rocker-bogie mechanism equipped with six non-steerable grip wheels, while requiring only approximately 17% of the total average wheel torque. In addition, the robot successfully climbed a 40 cm step with an average climbing time of 6.4 s, confirming its high turning and step-climbing performance.
The spine plays a crucial role in the dynamic locomotion of quadrupedal animals, improving the stability, speed, and efficiency of their gait, especially for fast-paced and highly agile movements. Therefore, the spine is also a promising and natural way to extend the capabilities of quadruped robots. This paper empirically investigates the benefits of an actuated spine for learning agile quadruped locomotion. We evaluate whether the use of the spine brings benefits in terms of high-speed running, climbing stairs, climbing high-angle slopes, hurdling, and crawling scenarios. We conducted an empirical study in MuJoCo simulation using the Silver Badger robot from MAB Robotics with an actuated 1-DOF spine in the sagittal plane. The obtained results show that the use of the spine provides the robot with increased agility and allows it to overcome higher stairs, steeper slopes, higher obstacles, and smaller passages.
Tracked robots are widely used in unstructured environments; however, their obstacle traversal capability is fundamentally limited by a tradeoff between front-end reachability and locomotion stability. This study presents TRASER (Tracked Robot with Articulated Spine for Extended Reach), a reconfigurable tracked robot capable of relocating both its articulation point and internal mass. TRASER employs a tape-spring mechanism that localizes compliance to the bending region while maintaining high stiffness in the remaining body, thereby improving both front-end reachability and center-of-mass (CoM) shifting capability. Geometric and static models are developed to analyze the effects of articulation point and CoM position on step and ditch traversal performances. Experiments demonstrate step traversal, suspended-platform traversal, and ditch traversal of 74%, 66%, and 59% of the robot body length, respectively. To the best of our knowledge, these results represent the highest reported obstacle traversal capabilities among tracked mobile robots.
This paper presents KYON, a hybrid wheel-legged quadruped robot equipped with a bimanual upper body for loco-manipulation tasks. The platform features a semi-modular design with a reconfigurable lower legs, enabling both wheeled and legged locomotion depending on the environment. A design approach that places actuators in the base and uses transmission mechanisms reduces distal inertia, improving agility and dynamic performance. The robot integrates a whole-body control framework together with a reinforcement learning based policy to handle nonlinear dynamics and enhance robustness to disturbances for the execution of locomotion and manipulation tasks, independently. Experimental results demonstrate effective dynamic locomotion and bimanual manipulation, validating the platform's capability to operate in complex and unstructured scenarios.
Luca Rossini, Arturo Laurenzi, Francesco Ruscelli +8