cs.AINov 6, 2025

Flow Reconstruction from Sparse Measurements in Urban Drainage Networks: A Simulation-Based Evaluation of Data-Driven Sparse Sensing

Authors: Zihang Ding, Amit Kumar, Imran Md. Azizul Islam, Mila Avellar Montezuma, Ruihang Zhang, Kun Zhang

Organizations: Department of Civil and Environmental Engineering, University of Minnesota Duluth, Duluth, Minnesota, United States · IHE Delft Institute for Water Education; Rede CLIMA-Brazilian Research Network on Global Climate Change (Ministry of Science Technology and Innovation of Brazil), Brazil · Department of Mechanical and Industrial Engineering, University of Minnesota Duluth, Duluth, Minnesota, United States

Abstract

Urbanization and increasingly frequent intense storms are placing stress on urban drainage networks. While dense monitoring is desirable, practical constraints in time, budget, and technology hinder its full implementation. How to monitor and predict flow conditions across the entire network under constrained resources is a major challenge. To address this, we evaluated data-driven sparse sensing (DSS), which selects sensor locations and reconstructs network-wide flow from the same reduced basis, in a 76-conduit urban drainage network. Simulations of a calibrated SWMM model were used to construct an event-weighted spatial basis using singular value decomposition (SVD), select rank-specific layouts using pivoted QR, and define the reconstruction decoder. Applied to 225 held-out simulations combining 25 plausible calibrated parameter sets with nine rainfall events, monitoring 5 of the 76 conduits (6.6%) achieved a median system-level Nash-Sutcliffe efficiency (NSE) of 0.992 (10th percentile 0.973) for observed storms, and a median NSE of 0.967 at the active unmonitored conduits. Pivoted QR performed comparably to genetic-algorithm layouts without requiring iterative layout searches, whereas largest-upstream-area placement failed with the DSS decoder and trailed QR even with a weighted regression decoder. The DSS flow reconstruction performance was insensitive to prescribed multiplicative Gaussian measurement noise, additive noise up to about 2 L/s and a 10 L/s detection floor, but showed location-dependent responses to loss of a monitored conduit, which a refitted regression decoder largely removed. This study supports the use of DSS, driven by physics-based simulations, for deciding how many flow sensors to install and where.

Explore similar work

May 30, 2025

Diff-SPORT: Diffusion-based Sensor Placement Optimization and Reconstruction of Turbulent flows in urban environments

Rapid urbanization demands efficient monitoring of turbulent wind and pollutant dispersion, yet existing reconstruction and sensor placement strategies fail under realistic sparsity constraints. Here, we introduce Diff--SPORT, a diffusion-based framework that combines a generative diffusion prior with maximum a posteriori inference and Shapley-value attribution for high-fidelity flow reconstruction and optimal sensor placement. By training a diffusion prior model once over a domain, Diff--SPORT enables non-linear optimal sensor placement and near-real-time flow reconstruction from sparse measurements orders of magnitude faster than RANS or LES simulations, consistently outperforming state-of-the-art methods. The framework also extends, without algorithmic modification, to experimental passive scalar concentration dataset, a direct proxy for pollutant dispersion, measured in a 1:2400 scale water-flume model of the Beijing Haidian neighbourhood under realistic urban flow conditions. Shapley-guided sensor placement achieves up to 57% lower reconstruction error than randomly placed sensors at extreme sparsity, identifying compact and physically interpretable configurations. These results establish Diff--SPORT as a modular foundation offering a zero-shot alternative to retraining-intensive downstream strategies, supporting scalable urban flow monitoring for air quality management and resilient city design.
Nov 4, 2026

FlowReconBench: Accuracy, calibration and cost of learned and classical flow reconstruction from sparse sensors

Reconstructing full flow fields from sparse sensors requires prior assumptions about unmeasured regions and physical variables. Yet it remains unclear when learned models outperform classical estimators and which aspects of their predictions can be trusted. FlowReconBench evaluates ten learned and five classical methods on three regimes: a laminar cylinder wake across Reynolds numbers, two-dimensional Kolmogorov turbulence and a large-scale three-dimensional (3D) isotropic turbulence. Methods share leakage-controlled splits and sensor draws and are scored on per-channel error, ensemble spread, calibration, spectra and cost. The leading method changes for each regime. Classical methods perform strongly in low-order and dense-sensing regimes. On the cylinder wake, linear stochastic estimation and gappy proper orthogonal decomposition lead, including for unobserved pressure. In 3D, inverse-distance weighting matches the best learned methods on observed channels. Data-driven methods become superior at decreasing sensor density or poor sensor observability. On Kolmogorov flow, continuous ranked probability score and error yield different method rankings: generative models offer broader but underdispersed ensembles, while deterministic models prioritize pointwise error. Generative models balance this tradeoff through their sampler budget, with a larger budget improving ensemble quality at higher computational cost. In 3D, scaling tests demonstrate that queryable methods are flat in memory, while full-grid construction methods run out of memory. Observing only 2 of 4 fields leaves the problem kinematically underconstrained, yet a latent model can reproduce structural similarities to the ground truth.
Jun 22, 2026

Simulation-Free Estimation of Traffic Flows from Sparse Count Data

We propose a method for estimating time-varying traffic flow patterns from sparse aggregated vehicle counts. The method partitions the study area into spatial regions, constructs a set of feasible region-to-region routes, and solves a weighted least-squares optimization problem to determine the number of vehicles to allocate on each route. A weighted contribution matrix encodes sensor coverage, steering the optimizer toward flow configurations that are directly observable by sensors. Edge-level trajectories are then derived by scoring candidate routes against the temporal and volumetric profiles of aggregated regional sensor counts. The method is evaluated on the Brussels road network using real and synthetic traffic data. Results show that the proposed approach reproduces the daily traffic profile in the input data and outperforms the baseline methods at a fraction of the computational cost.