Model-based thermal drift compensation for high-precision hexapod robot actuators

Electrically-actuated quadrupedal robots possess high mobility on complex terrains, but their motors tend to accumulate heat under high-torque cyclic loads, potentially triggering overheat protection and limiting long-duration tasks. This work proposes a thermal-aware control method that incorporates motor temperatures into reinforcement learning locomotion policies and introduces thermal-constraint rewards to prevent temperature exceedance. Real-world experiments on the Unitree A1 demonstrate that, under a fixed 3 kg payload, the baseline policy triggers overheat protection and stops within approximately 7 minutes, whereas the proposed method can operate continuously for over 27 minutes without thermal interruptions while maintaining comparable command-tracking performance, thereby enhancing sustainable operational capability.

Motor thermal management is often overlooked in the context of electrically-actuated robots, particularly legged robots, but motor overheating is a key factor that limits long-duration locomotion especially under payload conditions. This paper integrates a whole-body thermal model of a quadruped robot into the reinforcement learning pipeline to update motor temperatures, and proposes a two-stage training framework for motor thermal management. In this framework, a nominal policy is first pre-trained as a locomotion baseline capable of traversing diverse terrains. A residual policy is then trained on top of the nominal policy to provide corrective actions based on the robot's thermal state, ensuring high performance under low-temperature conditions and preventing motor overheating under high-temperature conditions. Simulation results demonstrate that the proposed policy achieves an effective balance between motor thermal safety and locomotion performance. Real-world experiments on a Unitree A1 quadruped robot further validate the approach: under a 3 kg payload, the robot achieves stable locomotion across multiple terrains for over 13 minutes, while the nominal policy alone leads to motor overheating in about 5 minutes.

Industrial robots are rarely used for machining tasks due to their limited path accuracy. This accuracy is mainly limited by inaccuracies in the drive trains. Compliance and transmission errors occur in the joint gearboxes. While transmission errors have been extensively studied for strain wave gears, there is little research on these errors in cycloidal drives. This gearbox type is commonly used in industrial robots for medium to heavy payloads. It is proposed to model the mainly periodic transmission errors using a Fourier series where amplitude and phase are defined as a polynomial function of the main influence factors load-torque, velocity, and temperature. Measurements of the transmission errors were conducted using an experimental setup representing a single robot joint. In the evaluation of the measurement data, harmonic frequencies were related to mechanical properties of the cycloidal drive. These frequencies were used to identify the parameters of the polynomial Fourier series model. Compared to validation measurements, the derived model shows an average root mean square error of 0.026 mrad. It is proposed to use the output of the resulting model in a feedforward control approach to compensate the transmission errors and to increase the path accuracy of industrial robots.