CableTract: A Co-Designed Cable-Driven Field Robot for Low-Compaction, Off-Grid Capable Agriculture

Line-haul trucking costs are dominated by three comparably sized components: energy, driver labor, and equipment. Most efficiency technologies address only one component at a time. This paper presents Robostreet Flow, a freight architecture that jointly optimizes the vehicle, convoy formation, and operating model to minimize cost per ton-mile on high-volume point-to-point corridors. The Flow platform is a battery-electric 6x4 tractor with a teardrop single-seat cab and a drag coefficient of 0.35, approximately 40% below that of conventional Class 8 tractors. A carbon-composite monocoque and structurally integrated batteries reduce net vehicle weight by 50%. A 513 kWh tractor battery and a 340 kWh powered trailer battery provide a 500-mile single-charge range. Four Flow trucks operate as a coordinated convoy with a safety driver only in the lead vehicle, while three followers operate in SAE Level 4 automated mode. Computational fluid dynamics simulations show that close following at an 8 m gap reduces follower drag coefficients by 42-48% and follower peak frontal pressure by approximately a factor of four relative to the exposed lead vehicle. A longitudinal energy model calibrated to these results predicts fleet-average consumption of 1.27 kWh/mi in convoy, compared with 1.60 kWh/mi for an isolated vehicle, for a 20.5% energy saving. Electricity cost is approximately 17% of the equivalent diesel fuel cost. Amortizing one driver across four trucks and accounting for the additional payload enabled by lightweighting reduce operating cost from 9.4 to 4.1 cents per ton-mile, a 56% reduction relative to a diesel baseline. Sensitivity analysis, a hub-to-hub operating concept, and regulatory implications are also presented.

In efforts to increase research efficiency and availability, a digital twin of our research tractor (AMX G-trac) is created, focusing especially on the CAN communication for data reading and actuation command following the ISOBUS protocol. Mevea Simulation Software is utilized as the foundation, providing the kinematic model and visuals, while Python is used to read and write CAN messages over a Kvaser CanKing virtual CAN channel. Various performance tests involving straight line and turning behavior are performed in both the digital twin simulation and in the real world to measure similarity. Results indicate that the Mevea model behaves very comparable in its lateral dynamics, often within 5-10 percent, but requires better data to fully capture the longitudinal aspects like acceleration. The final model described in this paper sets the table for a second iteration to include more tractor functions such as hydraulics and tractor-implement dynamics.

Steering Cable-Driven Parallel Robots (CDPRs) beyond their Wrench-Feasible Workspace (WFW) augments their capabilities in challenging scenarios such as during aggressive maneuvers or following a cable failure. In this context, although the determination of cable tensions is a well-studied topic, only a few approaches address these scenarios. Therefore, this paper introduces an extended version of the Analytic Center method as a criterion for selecting cable tensions outside the WFW while maintaining differentiability and including non-linear constraints. Notably, the proposed method maintains continuous and differentiable tension profiles, ensures fast real-time convergence to a unique solution, and, in contrast to other slack-based formulations, relegates wrench errors to a negligible area of the WFW. Its superiority in terms of smoothness and wrench error is confirmed via Pareto dominance with respect to the leading state-of-the-art method. Lastly, the effectiveness of the method is demonstrated through numerical experiments.