Computational Design and Co-Robotic Fabrication for Material Reuse in Architecture

This paper presents Tessellated Biomes, a cyber-physical framework for the adaptive robotic construction and reconfiguration of modular multi-material assemblies. It challenges the linear lifecycle of standard construction by fusing (1) local microfactory fabrication, (2) discrete multi-material optimization, and (3) distributed robotic assembly into a unified circular process of spatial adaptation. The research details methods for the digital fabrication of self-aligning modular primitives in multiple materials (PLA, timber, and concrete) produced in local microfactories; the aggregation and optimization of these primitives into compression-based discrete structures; and the deployment of custom quadrupedal robots that collaboratively relocate material into realized physical aggregations. The framework is validated through the fabrication, optimization, and robotic assembly of discrete structures. Together, these results position Tessellated Biomes as a model for resilient, reconfigurable architecture.

Human-robot collaboration in construction is often challenged by limited robot-to-human communication and the need to adapt to tolerance accumulation arising from material and assembly uncertainties. We present an adaptive human-robot collaborative workflow for masonry construction that addresses communication limitations and tolerance accumulation, demonstrated through a brickwork case study in which a robot places bricks while a human applies adhesive. This workflow is enabled by two complementary mechanisms: 1) an end-effector-mounted projector that provides spatially registered, just-in-time projection guidance for manual adhesive application, and 2) laser scanning for feedback-driven grasping and placement pose correction. Together, these mechanisms enable adjustment of human and robotic actions in response to material variability and accumulated assembly tolerances. Full-scale experiments across conventional running-bond and nonstandard configurations demonstrate that projection guidance improves adhesive application consistency and reduces application time, while laser-based correction maintains level courses and avoids collision-prone failures associated with open-loop execution. These results indicate that integrating spatial projection with feedback-driven adaptation, enabled by material and as-built sensing, can mitigate tolerance accumulation and improve precision and robustness in human-robot collaborative construction.

Robotic construction systems often treat the material system and the robot as separate design problems, locating intelligence primarily in hardware, sensing, motion planning, and control. This project instead investigates how geometric intelligence can be encoded within architected material systems to simultaneously address requirements for robotic grasping, self-alignment, reversible connection, structural performance, and three-dimensional aggregation. We introduce a self-aligning compound nested lattice module composed of conjoined cuboctahedral-octahedral units. The cuboctahedral features of the modules provide defined surfaces for robotic grasping and alignment, while the octahedral features incorporate screw-releasable snap-fit connectors and corresponding receptors. Additionally, we present a nested arrangement that enables interlocking aggregation along the x, y, and z axes. We demonstrate the system through furniture and architectural scale structures assembled using both a robotic arm and mobile assembler. The resulting configurations include seating, spanning structures, surfaces, and vertical frames. Compression testing of the compound module produced a stiffness of 4,556 N/mm, a maximum load of 3,445 N, and a compressive modulus of 17.5 MPa. The modules can also be disassembled and reused across different configurations, supporting reconfigurable and circular construction.