FAM-DQ: A Dual-Quadrotor-Based Fully Actuated Aerial Manipulator for High-Torque Interaction

Uncrewed Aerial Manipulators (UAMs) extend the capabilities of Uncrewed Aerial Vehicles (UAVs) from perception to physical interaction. Among various aerial interactions, push-and-pull operations are fundamental manipulation primitives that require sustained horizontal forces while maintaining stable flight. In this paper, we propose DuctAM, a compact aerial manipulation platform that enhances horizontal force capability for push-and-pull interactions using two ducted fans integrated along the quadrotor interaction axis. An attitude-force decoupled control scheme enables controllable horizontal forces without requiring large attitude changes. Extensive real-world experiments are conducted to validate the DuctAM. Figure-eight trajectory tracking experiments demonstrate stable flight and accurate motion control in both quad and duct modes. Force-measurement experiments quantify the decoupled longitudinal force capability of DuctAM. Finally, representative push-and-pull interaction tasks, including cart pushing, door closing, and drawer opening, verify the practical effectiveness of DuctAM. The results show that DuctAM achieves significantly improved horizontal interaction force capability while maintaining stable flight compared with conventional UAVs.

Aerial physical interaction represents a promising direction for next-generation unmanned aerial vehicles (UAVs), but it requires an aerial platform that can exert contact forces while maintaining stable flight. For close-proximity tasks, this translates into three coupled design requirements: multidimensional wrench generation for stable contact, compactness for maneuverability and safety in confined spaces, and reduced lateral airflow toward the target when generating horizontal force. This article presents FLOAT Drone, a fully actuated coaxial UAV with servo-driven control surfaces for close-proximity physical interaction. The coaxial dual-rotor layout provides a compact propulsion layout, while the control surfaces, immersed in the rotor downwash, generate lateral forces and moments for 6-DoF wrench generation. A force-matched computational fluid dynamics (CFD) comparison with a tilted-rotor alternative quantifies the reduction in target-facing lateral airflow. To account for nonlinear rotor--control-surface coupling in the rotor wake, a high-fidelity polynomial aerodynamic wrench model is identified from precision force measurements and embedded in a constrained nonlinear allocator for real-time wrench tracking. Comparative flight and interaction experiments show that the proposed framework improves control accuracy over linear allocation baselines, rejects ground-effect and payload disturbances, and enables close-proximity drawer push--pull manipulation through a $2~\mathrm{cm}$ handle clearance.

Aerodynamic promptness quantifies how rotor-speed variations generate multirotor wrench variations, but its Euclidean formulation assigns the same local cost to a given rotor acceleration at every operating speed. This work develops a capacity-aware extension for redundant multirotors with arbitrary numbers of heterogeneous rotors and wrench components. Under bounded motor torque and aerodynamic drag, each generally asymmetric instantaneous rotor-acceleration interval contains a largest zero-centered subset whose radius defines the symmetric acceleration capacity (SAC). The SAC induces a Riemannian metric on the positive-capacity rotor-speed region. Propagating its co-metric through the nonlinear rotor-speed-to-wrench differential yields a state-attached task-rate capability matrix and ellipsoid. The corresponding inverse quadratic form equals the minimum normalized rotor-acceleration effort required to realize a prescribed wrench rate, while the ellipsoid volume defines the drag-aware aerodynamic manipulability (DAAM) index. Fiberwise DAAM maximization provides a task-coordinate-invariant criterion for selecting task-equivalent actuator states; its maximizing set exists on compact regular domains and can be nonconvex and set valued. Low-dimensional two- and three-rotor studies make the resulting fiberwise geometry and parameter dependence directly visible. A complementary two-rotor use case shows how DAAM can inform a continuous allocation section subject to directional motor-torque feasibility. For two heterogeneous propulsion systems, the resulting sections reduce saturation-induced force-tracking degradation relative to the pseudoinverse in the faster command bands