Multimodal Interaction Estimation for Contact-Aware Adaptive Impedance Control

Contact-rich manipulation requires robots to balance accurate motion tracking with compliant interaction, yet most visual-action policies leave compliance fixed at the controller level. We present Imp-ACT, a methodologically grounded and practical approach to incorporating direction-dependent Cartesian stiffness modulation directly into demonstration collection, without manual stiffness selection or offline target reconstruction. During teleoperation, a self-tuning impedance controller adapts stiffness along the instantaneous direction of motion while maintaining compliance in orthogonal directions. The adapted stiffness is applied and recorded alongside visual observations and motion commands, capturing motion and compliance under the same dynamics. We implement this pipeline using Action Chunking with Transformer (ACT) to predict end-effector pose, gripper action, and motion-direction stiffness from visual, proprioceptive, and wrench observations. The performance of Imp-ACT is evaluated on wiping and plug insertion using both success rate and quantitative measures of contact behavior. Compared with fixed low- and high-stiffness baselines, Imp-ACT achieves comparable or higher success while maintaining low interaction forces. In wiping, it reduces contact-force vibration by approximately $29\times$ relative to the compliant baseline and $180\times$ relative to the stiff baseline. In plug insertion, it reduces forces orthogonal to the insertion direction by $43\%$ relative to the better fixed-stiffness baseline. These results highlight the benefit of maintaining sufficient stiffness along the direction needed for task execution while preserving compliance in other directions to limit contact forces and accommodate environmental constraints.

Real-world robotic manipulation tasks often involve forceful interactions with the environment, such as using tools of varying weights, transporting objects with different masses, and performing contact-rich tasks like table wiping. Previous learning-based approaches typically employ imitation learning policies that output target end-effector poses tracked by low-level impedance controllers. In these systems, forceful interactions are either implicitly realized through steady-state tracking errors or explicitly commanded using wrist force/torque or tactile sensors. However, implicit approaches generalize poorly across object weights, while explicit approaches require specialized hardware and increase system complexity. In this work, we propose IMPACT, a framework that decouples these forceful tasks into task-planning and internal-model-based predictive control. Extensive simulation and real-world experiments demonstrate that the proposed framework achieves higher success rates and improved generalization to unseen object weights, as well as better safety and energy efficiency.

Maintaining balance under external hand forces is critical for humanoid bimanual manipulation, where interaction forces propagate through the kinematic chain and constrain the feasible manipulation envelope. We propose FAME, a force-adaptive reinforcement learning framework that conditions a standing policy on a learned latent context encoding upper-body joint configuration and bimanual interaction forces jointly, since the base moment a load induces depends on the arm configuration through which it acts. Training applies isotropically sampled 3D forces at each hand under an upper-body pose curriculum, exposing the policy to manipulation-induced perturbations across continuously varying arm configurations. At deployment the interaction force is not measured but reconstructed online from joint torques and states through rigid-body inverse dynamics, requiring no wrist force/torque sensing. We evaluate over $100$ upper-body configurations under swept hand forces, scoring each trial by a task-level criterion that requires the robot both to remain upright and to hold its hands near where the task placed them; all such results run with the estimated force in the loop. At a $150$,mm tolerance FAME reaches $38.9\%$ task success, against $16.6\%$ for a policy given the same force without encoding, $4.3\%$ for a pose-conditioned curriculum policy, and $24.7\%$ for an adversarially trained locomotion policy, which stays upright but recovers by stepping and so relocates the hands. We further demonstrate transfer to task-generated interaction forces in a MuJoCo kitchen environment, and to asymmetric and bimanual loading on a full-scale Unitree H1-2. Code and videos are available on the https://correlllab.github.io/fame_website.