Authors: Taro Tako, Takanori Jin, Hiroshi Kaminaga, Taisuke Kobayashi
Organizations: National Institute of Informatics (NII) and with The Graduate University for Advanced Studies (SOKENDAI), 2-1-2 Hitotsubashi, Chiyoda-ku, Tokyo, 101-8430, Japan · CNRS-AIST JRL (Joint Robotics Laboratory), IRL 3218, National Institute of Advanced Industrial Science and Technology (AIST), 1-1-1 Umezono, Tsukuba, Ibaraki 305-8568, Japan
Variable stiffness mechanisms that achieve both flexibility and rigidity are important technologies for robotic systems. Recently, wire-based jamming mechanisms have attracted significant attention. In the wire-based jamming mechanisms, modules are chained by a wire, and the overall stiffness is controlled by changing the friction between the modules through wire tension. These mechanisms have been widely studied due to their simple structure and controllability. However, conventional wire-based jamming mechanisms mainly focus on holding torque along the joint axis, and the resistance against disturbances in other directions has not been sufficiently explored. In this study, we propose a wedge-jamming mechanism that introduces wedge-shaped contact surfaces into the modules of wire-based jamming structures. By changing the wedge angle, the holding characteristics against disturbances in different directions can be adjusted. Experimental results show that an out-wedge configuration improves resistance to vertical disturbances, while an in-wedge configuration enhances resistance to torsional disturbances. These results demonstrate that the anisotropic holding performance of wire-based jamming mechanisms depend on wedge geometry.
Figures & tables
Figure 1: Principle of wire-based jamming mechanism
Figure 2: Two types of jamming mechanism
Figure 3: Perspective and side view of bead module
Figure 4: Perspective and side view of wedge module
Figure 5: Side view of bead and wedge module
Figure 6: Design illustration of proposed modules
Figure 7: Force test bench used to evaluate the holding torque of the wire-based jamming mechanism
Figure 8: Torsion test bench used to evaluate the torsional holding torque of the wire-based jamming mechanism. The series elastic actuator applies a torsional torque to the module, and the angular displacement is measured using the motor encoder.
Figure 9: The image of three types of disturbance directions: joint-axis direction, perpendicular to joint-axis direction and torsional
Figure 10: Relationship between wire tension and holding torque in the joint-axis direction disturbance
Figure 11: Relationship between wire tension and holding torque in the perpendicular to joint-axis direction disturbance
Figure 12: The experiment environment of relationship between the number of joints and average holding torque. In this image, it shows the example of pivot position 7th.
Figure 13: Holding torque in the joint-axis direction disturbance direction with different pivot position
Figure 14: Holding torque in the perpendicular to joint-axis disturbance direction with different pivot position
Figure 15: The figure shows the behavior of bead and out-wedge modules in slow motion when a perpendicular to joint-axis disturbance is applied with the pivot position set at the 7th from the base plate. The upper figure shows the bead modules, and the lower figure shows the out-wedge modules.
Figure 16: Relationship between torsional torque, angular displacement, and wire tension
State Key Laboratory of Mechanical Systems and Vibration, Shanghai Jiao Tong University, Shanghai 200240, China · Department of Mechanical Engineering, Stanford University, USA · Shanghai Key Laboratory of Intelligent Robotics; META Robotics Institute, Shanghai Jiao Tong University, Shanghai 200240, China +1