Interaction Forces and Internal Loads in Parallel Manipulators with Actuation Redundancy

Real-world robotic manipulation tasks often involve forceful interactions with the environment, such as using tools of varying weights, transporting objects with different masses, and performing contact-rich tasks like table wiping. Previous learning-based approaches typically employ imitation learning policies that output target end-effector poses tracked by low-level impedance controllers. In these systems, forceful interactions are either implicitly realized through steady-state tracking errors or explicitly commanded using wrist force/torque or tactile sensors. However, implicit approaches generalize poorly across object weights, while explicit approaches require specialized hardware and increase system complexity. In this work, we propose IMPACT, a framework that decouples these forceful tasks into task-planning and internal-model-based predictive control. Extensive simulation and real-world experiments demonstrate that the proposed framework achieves higher success rates and improved generalization to unseen object weights, as well as better safety and energy efficiency.

Force signals provide critical interaction cues for contact-rich robotic manipulation. However, existing methods mostly use force as an additional observation modality, without fully exploiting its role in modeling future interaction dynamics or guiding execution-time feedback correction. In this paper, we propose FAWAM, a force-aware world action model that incorporates force information at three levels: perception, prediction, and closed-loop execution. FAWAM first encodes historical 6-axis force/torque signals to modulate action generation, then jointly predicts future actions and end-effector wrenches to explicitly model contact evolution. It further introduces a residual correction module that uses the predicted wrench trajectory as an execution-time reference to refine actions online based on real-time force feedback. Real-world experiments across multiple contact-rich tasks show that FAWAM improves the average success rate by 36.25% over vision-only baselines and 21.25% over existing force-aware baselines, demonstrating the effectiveness of our force-aware framework for robust contact-rich manipulation.

This paper proposes actuator-aware inverse kinematics for torque-controlled redundant robots under joint-limit constraints. In the considered architecture, the inverse-kinematic output is not merely a purely kinematic joint-velocity command; it is the required joint velocity supplied to a downstream torque-level controller. Therefore, a small commanded task residual may not necessarily improve realized motion. The proposed method formulates a convex quadratic programming problem whose decision variable is the joint-level required velocity. Control barrier function style bounds impose reference-level joint-limit admissibility, while the task equation is handled through a penalized slack variable. Redundancy is resolved using a controller-compatibility objective that accounts for previous-command consistency and actuator torque-capacity weighting. The method is independent of the particular torque-level controller and can serve as an intermediate IK layer between an endpoint trajectory and a redundant robot controller. Experiments on a virtual-decomposition-controlled seven-degree-of-freedom upper-limb exoskeleton compare the method with standard inverse-kinematic baselines and a constrained task-preserving quadratic programming baseline. The results indicate lower limit-pushing commands, bounded admissible required velocities, and improved realized task behavior in the tested trajectory, without modifying the downstream controller.