Estimating the precise timing of batting impact is crucial for understanding the rapid sensorimotor control. However, this task is challenging for RGB cameras due to insufficient temporal resolution and motion blur. Similarly, Inertial Measurement Units (IMUs) are impractical for actual matches due to sensor intrusiveness and their limited temporal precision. To overcome these limitations, we propose a novel framework leveraging event-based cameras, which offer microsecond resolution and high dynamic range, to estimate impact timing based on the weighted centroid distance between the detected ball and bat. To address the domain gap between event frames and RGB images that degrades segmentation accuracy, we generate high-density event frames. We then introduce a mask refinement network that leverages these frames and bidirectional mask information, optimized using a novel loss function. Experiments on real-world datasets demonstrate that our method achieves superior accuracy under challenging conditions, including low-light environments and severe occlusions, outperforming baselines by reducing the Mean Absolute Error by approximately 63%.
Robotic table tennis has emerged as a compelling benchmark for real-time robotic perception due to its fast ball dynamics and stringent timing requirements. Accurate, high-frequency, and low-latency ball state estimation is critical for reliable trajectory prediction and timely control. Traditional frame-based cameras face an inherent trade-off: low frame rates leave temporal blind spots that miss fast-moving objects and high frame rates raise data and computational cost. Event cameras instead offer microsecond temporal resolution and, under sufficient illumination, remain largely free of motion blur even at high ball speeds. However, the community lacks large-scale datasets to develop and benchmark event-based perception in realistic sports scenarios. We address this gap by introducing the first large-scale event-camera dataset for table tennis, comprising over 1000 rallies from a diverse group of players ranging from amateurs to elite-level athletes. Each recording captures the event stream alongside 14 synchronized high-speed frame-based cameras at 200 FPS, which we use to produce 1 kHz pseudo ground-truth labels for ball position, velocity, and spin. Building on this dataset, we train a convolutional neural network robust to background player motion that jointly estimates the ball's position and velocity in the image-plane from events. Treating the predicted velocity as an additional measurement in the Kalman filter reduces bounce-point prediction error by 36% relative to a position-only baseline. Finally, we close the perception-action loop by integrating the event-based system with a Stäubli robotic arm, enabling the first real-time human-robot table tennis rallies driven by event-based perception.
Quantifying impact phenomena in badminton smashes is important for evaluating both athletic performance and equipment; however, conventional measurement systems involve trade-offs between temporal resolution, data efficiency, and preparation effort. This study proposes a measurement method using two synchronized event cameras to automatically estimate impact time, impact location on the racket face, and post-impact shuttlecock speed in an integrated manner within the same trial. The swing interval was detected from event rate statistics, impact time was estimated from the shuttlecock trajectory inflection in the lateral-view event data, impact location was determined by ellipse fitting to the racket face in the rear-view event image, and shuttlecock speed was calculated in the sagittal plane. To validate the proposed method, Bland-Altman analysis was performed against a high-speed camera-based reference method using 125 smash trials from five players. Impact time and shuttlecock speed were estimated in all 124 analyzable trials, and impact location was estimated in 93.5% (116/124). The bias (95% CI) for impact time, medio-lateral impact location, longitudinal impact location, and shuttlecock speed were 1.84 ms (1.45 to 2.23), 3.45 mm (2.18 to 4.72), -1.92 mm (-2.97 to -0.88), and -1.00 m/s (-2.46 to 0.46), respectively. No proportional bias was observed for any metric. These results suggest that the proposed method can serve as a useful tool for integrated assessment of badminton smash performance and equipment in practical settings.
Spin plays a crucial role in many ball sports due to its effect on the trajectory of the ball. Vision-based estimation of the ball's spin during a game with conventional cameras is challenging due to the ball's small size, high speed, and fast rotation. To address these challenges, we propose an event-based active vision system that can track unmodified balls and measure their spin in real time. The system consists of an event camera for its high temporal resolution and minimal motion blur, high-speed pan/tilt galvanometer mirrors to keep the ball in the field of view, and a low-latency focus-tunable telephoto lens to increase the spatial resolution on the ball and keep it in focus. To track the ball, we use a hybrid approach that combines 2D event-based detection for centering and 3D positions from a ball localization system for re-initialization. For high-accuracy spin estimation, we propose an offline method that performs contrast maximization on the sphere (s-CMax). This method achieves state-of-the-art accuracy on static balls across multiple sports (table tennis, baseball, tennis, and golf), with mean magnitude and axis errors of 1.2% and 1.5 degrees, respectively. We then develop a low-latency online method for table tennis as a case study in real-time applications. This method uses an uncertainty-aware convolutional neural network trained on pseudo-ground-truth spin labels from the offline approach, combined with a GPU-accelerated batch implementation of contrast maximization for refinement. We demonstrate reliable tracking and spin estimation with a three-view setup during professional table tennis matches, with high accuracy (8.8% magnitude and 6.4 degrees axis mismatch w.r.t. the offline method), 3 ms latency, and 750 Hz throughput.