Decentralized UAV Swarms for Ground Target Protection in GPS- and Communication-Denied Environments

Cooperative UAV-swarm defenses commonly cross-check GNSS positions against measured inter-drone geometry. We show that this relative-geometry channel has a structural blind spot: a common, slowly varying translation (a rigid-covert shift, RigidShift) preserves all pairwise distances and is therefore unobservable to any relative-only detector (a gauge-freedom argument). We validate this blindness on distance-verification and semidefinite-feasibility baselines, while explicitly distinguishing it from onboard inertial/GNSS monitors that can raise a bare alarm but cannot recover the swarm's true position. To quantify when an external reference restores observability, we derive the drift-dependent detection floor $2γ/(1-t_s/T)$ for a calibrated anchor-residual detector and empirically identify an additional detector-specific noise floor (measured slope 2.66 vs. predicted 2.67). We then present a centralized anchor-rooted recovery pipeline that reconstructs swarm geometry from inter-drone ranges, aligns it to a trusted-anchor subset with Byzantine-robust fitting, and recovers the absolute positions of non-anchored drones. A segmented estimator jointly estimates anchor drift, attack rate, and onset when no clean-epoch label is available. Across statistical simulations, ArduPilot software-in-the-loop experiments, and Gazebo experiments with rendered vision anchors, the method recovers the positions of non-anchored drones to a median error of 0.39 m (20 seeds) under approximately 10.1 m of GNSS drift, and to 7.1 cm (5 seeds) in the rendered-vision multi-SITL setting. We also characterize the explicit limits imposed by non-collinear anchor geometry, anchor coverage, $τ\to0$ drift-attack aliasing, and majority anchor compromise. All evaluations are simulation-based and use no RF spoofing hardware or physical swarm.

Reliable real-time 3D localization is essential for multi-UAV navigation, collision avoidance, and coordinated flight, yet onboard estimates can degrade under GNSS multipath, non-line-of-sight reception, vertical drift, and intentional interference. This paper presents a decentralized, lightweight 3D position-refinement layer that improves robustness by fusing each Unmanned Aerial Vehicle (UAV)'s local estimate with neighbor-shared state summaries and inter-UAV range or proximity constraints. The method performs uncertainty-aware neighborhood fusion by weighting each UAV's prior according to its reported covariance and weighting neighbor constraints according to link quality, ranging uncertainty, and a learned trust score. To support practical deployment, the framework explicitly handles cold start and temporary localization loss by inflating or substituting weak priors, allowing trusted neighborhood constraints to bootstrap and stabilize estimates until absolute sensing recovers. To mitigate the impact of faulty or malicious participants, each UAV applies a local range-consistency check, smoothed over time, to down-weight or exclude neighbors whose reported positions are incompatible with observed inter-UAV distances. Simulation experiments with 10 UAVs in a 3D volume show that the proposed refinement substantially reduces mean localization error during cold start, remains competitive after local estimators stabilize, and maintains lower error as the fraction of malicious nodes increases compared with fusion without trust. These results suggest that the approach can serve as a practical resilience layer for swarm operation in challenging environments.

Thermal infrared (TIR) imaging is essential for UAV swarm operations in visually degraded environments. However, tracking tiny UAVs remains challenging due to limited appearance cues, frequent occlusions, and rapid maneuvers. Despite significant progress driven by benchmarks such as the Anti-UAV challenge, existing methods primarily prioritize accuracy while overlooking the computational constraints of real-time edge deployment. The standard Kalman Filter (KF) offers the efficiency required for edge devices, yet its constant-velocity assumption often breaks down under highly dynamic UAV motion and thermal sensor jitter. More sophisticated nonlinear estimators can improve robustness but often introduce additional computational costs. To address this gap, we propose an edge-aware online tracking pipeline centered on the Adaptive Kinematic Kalman Filter (AKKF), which augments the linear KF with state-dependent kinematic modeling while preserving real-time efficiency. Combined with transient false-positive suppression and kinematics-driven predictive coasting, the presented pipeline improves trajectory continuity under challenging TIR conditions. Experiments on the Beyond Strong Baseline (BSB) benchmark provide a starting point for edge-aware UAV tracking by jointly evaluating tracking performance and computational efficiency, offering insights toward future real-time deployment.