A Robotic System for Automated Manufacturing of Dielectric Elastomer Actuators

Dielectric elastomer actuators (DEAs) have garnered extensive attention especially in soft robotic applications over the past few decades owing to the advantages of lightweight, large strain, fast response and high energy density. However, because the DEAs suffer from nonlinear elasticity, inherent viscoelastic creep, hysteresis and vibrational dynamics, the modeling, control and self-sensing of DEAs are challenging, thereby hindering the practical applications of DEAs. In order to address these challenges, numerous studies have been conducted. In this review, various physics-based modeling methods and phenomenological modeling methods for predicting the electromechanical response of DEAs are presented and discussed. Different control methods for DEAs are reviewed, which are classified into open-loop feedforward control, feedback control, feedforward-feedback control and adaptive feedforward control. Physics-based self-sensing methods and data-driven self-sensing methods for reconstructing the DEA displacement without the need for additional sensors are discussed. Finally, the existing problems and new opportunities for the further studies are summarized.

Manufacturing complex soft pneumatic actuators remains challenging because geometric fidelity, compliance, structural integrity, and airtightness must be achieved simultaneously. This study presents a manufacturing-focused evaluation of several fabrication routes for complex pneumatic structures, including heat-shrink forming, silicone casting, powder- and liquid-based additive manufacturing, and fused deposition modeling (FDM). The processes were assessed through process screening, baseline fabrication, failure analysis, and process improvement to distinguish inherent process limitations from correctable manufacturing defects. Heat-shrink forming was limited by geometric conformity, casting by mold accessibility and bonded interfaces, powder-based methods by residual material trapped within enclosed passages, and digital light processing by the material properties and post-processing requirements of the investigated system. FDM provided the most adaptable route because its dominant defects could be progressively reduced through process optimization. The results further showed that airtightness depends not only on nominal wall thickness but also on extrusion-path architecture, while support-free geometry is important when access for internal post-processing is limited. These findings establish a practical design-for-manufacturing approach in which process selection is guided by the compatibility between actuator architecture and manufacturing constraints. The proposed approach provides practical guidance for developing complex, flexible, and airtight soft pneumatic actuators for soft robotic applications

Spin coating is widely used for fabrication of thin polymer and elastomer films, yet reliable thickness verification of highly compliant materials remains challenging due to deformation from contact-based measurements and the cost and complexity of conventional optical metrology. Accurate thickness control is especially critical in soft elastomer applications such as dielectric elastomer actuators (DEAs), where mechanical and functional performance scales strongly with film thickness. This work presents a low-cost, primarily 3D-printed benchtop spin coater with an integrated, minimally deforming optical thickness measurement system for soft-film fabrication workflows. The system is designed to manufacture films between 50 and 300 microns thick with repeatability within 10 microns. Thickness is measured in-situ by tracking displacement of a reflected laser beam via quadrant photodetector, avoiding significant deformation. Optical geometry, sensor linearity constraints, and structural validation via finite element analysis are discussed. Experimental validation using calibrated metal shims demonstrated a thickness resolution of 3.6-3.7 microns and best-case measurement repeatability of 13 microns (95 percent confidence interval). The platform repeatably produced silicone films within 9 microns of target thickness, demonstrating that accessible optical metrology can be integrated into a low-cost spin coating system for practical, thickness-controlled fabrication of compliant thin films without specialized industrial instrumentation.