cs.RONov 17, 2026

Learning Accurate End-Effector Trajectory Tracking with Inertial Feedback for a Quadruped Manipulator

Authors: Dohyeon Kim, Seungyong Han, Yeongtae Jung

Organizations: Graduate School of Mechanical-Aerospace-Electric Convergence Engineering, Jeonbuk National University, Jeollabuk-do 54896, Republic of Korea. · Department of Mechanical System Engineering, Jeonbuk National University, Jeollabuk-do 54896, Republic of Korea. · Advanced Transportation Machinery Research Center, Jeonbuk National University, Jeollabuk-do 54896, Republic of Korea.

Abstract

Accurate end-effector trajectory tracking on quadruped manipulators is challenging because uncertainties in actuators, foot-ground contact, and geometric errors are propagated through the leg-arm kinematic chain. Detecting such errors requires sensing beyond joint encoders that can capture the effects of these uncertainties on the robot's motion, since joint encoders only provide measurements at the actuated joints and cannot fully observe mechanical errors such as backlash, dimensional inaccuracies, or structural deformation. This work addresses these challenges using a reinforcement learning framework with end-effector (EE) inertial feedback, targeting local high-accuracy manipulation while maintaining a nominal body pose and support configuration without intentional body motion or foot repositioning. The learned policy uses EE inertial measurements to compensate for tracking errors induced by uncertainties throughout the leg-arm system that cannot be fully inferred from proprioception alone. Simulation and real-world experiments on continuous EE trajectory tracking show overall improvements relative to nominal and proprioception-only baselines. In real-world experiments, the proposed policy reduces the MoCap-based RMSE by 17.3% and 28.0% relative to the nominal baseline under the two in-distribution (ID) command conditions, respectively, and by an additional 12.6% and 15.9% relative to the proprioception-only baseline. Furthermore, the trajectory-wise RMSE between FK-reconstructed and motion-capture-measured end-effector positions averaged 12.61+-2.15mm (mean+-standard deviation) across 24 controller-trajectory combinations, revealing a substantial discrepancy between nominal kinematic reconstruction and measured end-effector motion.

Figures & tables

Explore similar work

CardsList
  1. Reinforcement Learning Based Multi-Terrain Adaptive Whole-Body Control for a Quadruped Manipulator

    Oct 16, 2026Yanzhou Jin, Fei Suo, Chang Liu +5Legged RoboticsWhole-Body Control

  2. Precise SE(3) End-Effector Tracking in Whole-Body Humanoid Control

    Oct 7, 2026Joohwan Seo, Xiaofeng Guo, Jinkun Cao +4Humanoid Robot ControlWhole-Body Robotic Manipulation