Ground-based free-flyer testbeds reproduce the planar motion of a free-floating spacecraft using air bearings, but not the relative dynamics of spacecraft in orbit. We present a dual-actuation architecture that physically emulates Clohessy-Wiltshire dynamics on an open-source free-flyer. Two model predictive controllers run in parallel: one drives the solenoid thrusters with an orbital dynamics model, representing the spacecraft under test; the other drives bidirectional propellers that physically apply the orbital accelerations, continuously updating its reference to account for thruster-induced velocity changes. A dynamic similitude maps the orbital scenario onto the limited floor area and actuation rates of the testbed, letting the spacecraft controller run directly at orbital scale. We validate the architecture on hardware and against a high-fidelity orbital simulation, where the orbital accelerations instead arise naturally, both driven by the identical spacecraft controller. Their agreement indicates that the testbed reproduces the relative orbital motion the controller would encounter in flight.
Figures & tables
Fig. 1 : Unforced relative motion in the target-centered Hill frame H , showing the along-track drift of a radially offset chaser over successive orbits.
Fig. 2 : Dual-actuation control architecture. The spacecraft planner and spacecraft Model Predictive Controller (orbital scale) generate and track the spacecraft mission trajectory; the commanded thrust updates the Clohessy–Wiltshire reference generator, which feeds the reference tracked by the Clohessy–Wiltshire dynamics Model Predictive Controller (laboratory scale). Λ and Λ−1 denote the scaling between orbital and laboratory frames. Subscript k:k+N denotes a trajectory over the prediction horizon and subscript k a single value at time step k . The spacecraft Model Predictive Controller commands the solenoid thrusters, while the Clohessy–Wiltshire dynamics Model Predictive Controller drives the bidirectional propellers to impose the scaled relative dynamics. The ATMOS free-flyer is shown equipped with the new propeller module.
Fig. 3 : Hardware results on ATMOS, shown at orbital scale ( λt=50 , λl=100 , λF=λmλl/λt2=0.32 ). Left column: spacecraft Model Predictive Controller; right column: Clohessy–Wiltshire dynamics Model Predictive Controller. The chaser first holds three unstable static formations relative to the target, and then at t≥110min follows two consecutive stable relative orbits. Top: measured (solid) and reference (dashed) radial px and along-track py positions. Middle: position tracking error. Bottom: commanded body forces. In the stable orbits, the spacecraft thrust nearly vanishes while the propellers supply the continuous Clohessy–Wiltshire accelerations.
Fig. 4 : Basilisk reference results, at the native orbital scale. Only the spacecraft Model Predictive Controller runs since the nonlinear orbital dynamics of Basilisk replace the Clohessy–Wiltshire dynamics Model Predictive Controller. Without modeled disturbances, the controller tracks the reference closely and coasts on the stable orbits ( t≥110min ).
This work presents a control framework that enables a multicopter equipped with a two-axis gimbal to emulate the flight dynamics of a fixed-wing aircraft. The goal is to provide an operationally simple platform for training and simulation that avoids the aerodynamic constraints of fixed-wing vehicles, such as minimum airspeed and nonholonomic constraints. A state-input mapping between the two platforms is derived using dynamic feedback linearization. The framework is evaluated on representative fixed-wing manoeuvres. Results show high-fidelity emulation under nominal conditions. While evaluations are conducted in simulation, the approach establishes a practical path toward hardware deployment for pilot training, autonomy research, and controller benchmarking.
Abdelhakim Amer, Andriy Sarabakha
Department of Electrical and Computer Engineering, Aarhus University, Denmark
Low-cost planar air-bearing testbeds have matured into a standard proxy for free-flying spacecraft GNC, but they remain largely thruster-only and are rarely equipped for contact-rich, inertia-coupled manipulation. Building on the open-source ATMOS testbed, we contribute a reaction wheel and two force/torque-sensed robotic arms (LEVION) with interchangeable end-effectors, integrated as first-class control actuators through a unified ROS 2 abstraction layer. On top of the software stack we build a reinforcement-learning training environment and digital twin, and a controller that exploits these added degrees of freedom, letting classical optimal controllers and learned policies be swapped on the same hardware without modification. We validate the integrated system, PINGU, across four benchmark tasks: point-to-pose navigation (classical LQR vs. sim-to-real PPO), dynamic disturbance rejection under arm-induced center-of-mass shifts, reaction-wheel momentum stabilization, and force-controlled docking. The results show that these additions extend an ATMOS-class emulator into the contact-rich regime and bridge classical optimal control and reinforcement learning on one reproducible platform.
Ricard Marsal I Castan, Akiyoshi Uchida, Aman Arora +7
University of Luxembourg · Tohoku University · Georgia Institute of Technology
We present a modular, high-fidelity simulation framework for the development and benchmarking of flight control strategies in fixed-wing aerial robots operating near the ground. Unlike existing simulators that rely on simplified or hover-oriented dynamics, our framework models full 6DoF rigid-body physics, semi-empirical ground-effect aerodynamics, actuator dynamics, sensor noise, and environmental disturbances. This physical realism, combined with modular component design, enables systematic analysis of low-altitude flight behavior under realistic conditions. The simulator supports both CPU and GPU backends via Torch and NVIDIA Warp, enabling high-throughput parallel execution suitable for large-scale reinforcement learning training and optimal control rollouts. A unified interface accommodates a range of controllers (both RL and optical control algorithms) across tasks such as altitude regulation and trajectory tracking. Cross-validation with X-Plane and JSBSim is also supported to facilitate engineering integration and visual fidelity.
Matteo El Hariry, Pedro Lima, Andrej Orsula +2
Interdisciplinary Centre for Security, Reliability and Trust (SnT), University of Luxembourg, L-1855 Luxembourg · Earth Speacies Project