Ground-based free-flyer testbeds reproduce the planar motion of a free-floating spacecraft using air bearings, but not the relative dynamics of spacecraft in orbit. We present a dual-actuation architecture that physically emulates Clohessy-Wiltshire dynamics on an open-source free-flyer. Two model predictive controllers run in parallel: one drives the solenoid thrusters with an orbital dynamics model, representing the spacecraft under test; the other drives bidirectional propellers that physically apply the orbital accelerations, continuously updating its reference to account for thruster-induced velocity changes. A dynamic similitude maps the orbital scenario onto the limited floor area and actuation rates of the testbed, letting the spacecraft controller run directly at orbital scale. We validate the architecture on hardware and against a high-fidelity orbital simulation, where the orbital accelerations instead arise naturally, both driven by the identical spacecraft controller. Their agreement indicates that the testbed reproduces the relative orbital motion the controller would encounter in flight.
Figures & tables
Fig. 1 : Unforced relative motion in the target-centered Hill frame H , showing the along-track drift of a radially offset chaser over successive orbits.
Fig. 2 : Dual-actuation control architecture. The spacecraft planner and spacecraft Model Predictive Controller (orbital scale) generate and track the spacecraft mission trajectory; the commanded thrust updates the Clohessy–Wiltshire reference generator, which feeds the reference tracked by the Clohessy–Wiltshire dynamics Model Predictive Controller (laboratory scale). Λ and Λ−1 denote the scaling between orbital and laboratory frames. Subscript k:k+N denotes a trajectory over the prediction horizon and subscript k a single value at time step k . The spacecraft Model Predictive Controller commands the solenoid thrusters, while the Clohessy–Wiltshire dynamics Model Predictive Controller drives the bidirectional propellers to impose the scaled relative dynamics. The ATMOS free-flyer is shown equipped with the new propeller module.
Fig. 3 : Hardware results on ATMOS, shown at orbital scale ( λt=50 , λl=100 , λF=λmλl/λt2=0.32 ). Left column: spacecraft Model Predictive Controller; right column: Clohessy–Wiltshire dynamics Model Predictive Controller. The chaser first holds three unstable static formations relative to the target, and then at t≥110min follows two consecutive stable relative orbits. Top: measured (solid) and reference (dashed) radial px and along-track py positions. Middle: position tracking error. Bottom: commanded body forces. In the stable orbits, the spacecraft thrust nearly vanishes while the propellers supply the continuous Clohessy–Wiltshire accelerations.
Fig. 4 : Basilisk reference results, at the native orbital scale. Only the spacecraft Model Predictive Controller runs since the nonlinear orbital dynamics of Basilisk replace the Clohessy–Wiltshire dynamics Model Predictive Controller. Without modeled disturbances, the controller tracks the reference closely and coasts on the stable orbits ( t≥110min ).