A wearable haptic device for edge and surface simulation

Wearable fingertip haptic devices are critical for realistic interaction in virtual reality, augmented reality, and teleoperation, yet existing approaches struggle to simultaneously achieve adequate tactile output, low mass, simple fabrication, and untethered portability. Here we show that fabric-based pneumatic actuation can address this gap. Our device comprises four pneumatic chambers fabricated from thermoplastic polyurethane-coated fabric via computer numerical control heat-sealing, yielding a soft, conformable interface weighing 2.1 g that operates untethered with a wrist-mounted control unit. Mechanical and dynamic characterization confirms that the fabric actuators produce sufficient force, displacement, and bandwidth for fingertip tactile rendering. A psychophysical study with 15 participants demonstrates classification accuracy exceeding 90% across three distinct tactile modes -- contact configuration, directional sliding, and vibrotactile frequency. These findings establish fabric-based pneumatic actuation as a viable technology route for lightweight, low-cost, and multimodal fingertip haptic interfaces.

Humans rely on directional fingertip forces to probe and regulate contact during manipulation, yet most wearable haptic gloves render only vibration or single-axis force, leaving force direction ambiguous. Without directional cues, users must infer contact force from vision alone, often leading to over-pressing, inconsistent control, and reduced precision in robotic teleoperation. We present the N2D Haptic Glove, a multi-finger wearable device that renders planar flexion-extension fingertip forces using capstan-drive transmissions for high-transparency force feedback. Through benchtop validations and a user study involving haptic teleoperation of a robotic arm and hand, we demonstrate that compared to visual-only and single-axis haptic baselines, planar fingertip feedback significantly reduces contact force error during precise manipulation, improves trial-to-trial consistency, and enhances overall user experience in axial probing tasks. These findings establish the N2D Haptic Glove and directional finger-based haptics devices as a promising modality for contact-rich teleoperation, immersive virtual reality simulations, and robot learning from demonstrations. N2D Haptic Glove's hardware and software system will be fully open-sourced at this https URL.

We present a system of two wearable pneumatic haptic devices that supports continuous, closed-loop, bidirectional tactile interaction at perceptually relevant force and temporal scales. A single device can contain up to twelve pressure sensing channels connected to textile-based pneumatic pouches. Each channel in a device can be used as a sensor, an actuator, or both. As an actuator with integrated sensing, the channel generates stable skin indentation through local closed-loop control. As a sensor, a channel can be mounted (or worn) on any surface, including on a robot gripper or on the human body, and used to measure touch interactions with the environment or a human user. A distributed architecture supports sustained pressure output, rapid dynamic response, and wireless pairing of identical devices in a system to transmit and reproduce tactile pressure signals in real time. Device-level characterization demonstrates force bandwidth exceeding 30 Hz, rapid and well-damped step responses, and extended pressure retention compared to prior compact pneumatic platforms. Human studies show that pressure-based fingertip feedback enables discrimination of force and stiffness, improves teleoperated manipulation by reducing applied pressures by up to 23.1% and task duration by up to 27.4%, and lowers subjective mental workload by 18.8%, particularly under visually constrained conditions. By unifying tactile sensing and haptic feedback within a single pneumatic modality, the device provides a practical foundation for bidirectional touch interaction in teleoperation.