Airspeed Forward-Invariance for Unpowered Fixed-Wing Aircraft
Authors: Huseyin Emre Tekaslan, Ella M. Atkins
Organizations: Kevin T. Crofton Department of Aerospace and Ocean Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24060, USA
Autonomous fixed-wing flight is becoming a key capability in aerial robotics, enabling sensing, mobility, and contingency operations across both small-scale Uncrewed Aircraft Systems and large-scale Advanced Air Mobility. During unpowered operation in fixed-wing platforms, airspeed is regulated solely through potential-kinetic energy exchange, making airspeed dynamics highly sensitive to guidance commands, particularly under wind. This paper presents a viability-based airspeed protection for ground-referenced guidance in steady wind, where airspeed evolution depends explicitly on the commanded flight path angle. Leveraging Nagumo's tangency condition, we derive a closed-form, wind-dependent characterization of admissible guidance commands that guarantees forward invariance of a safe airspeed envelope. These conditions are embedded within an offline quadratic programming framework to certify airspeed-safe maneuver primitives for non-ascending flight at the guidance level. The approach is validated using a high-fidelity unpowered fixed-wing aircraft model on gliding trajectories formed by concatenating certified maneuver primitives, demonstrating strict airspeed boundedness. Future work will address unsteady wind fields and flight experiments.
Gliding offers small fixed-wing UAVs extended endurance and silent operation but requires accurate energy management, especially under wind disturbances and obstacle constraints. Traditional Total Energy Control Systems based controllers regulate the trade between potential and kinetic energy reactively, often requiring fine-tuning and trim-conditions knowledge. In this work, we shift the regulation to the planning level and present a nonlinear, multi-cost trajectory planner for small UAV gliders. The method generates C3 continuous trajectories based on Bernstein polynomials, mapped into control commands through differential flatness, and re-planned online to match experimentally derived sink polar curves. A simulated netto variometer is integrated into the optimization to estimate air mass motion, constraining the glide to energy-balanced states. Consecutive gliding trajectories are linked by cruising segments computed through trajectories initialized on Dubins path-based waypoints, enabling hybrid missions that combine powered and unpowered flight. The approach is validated in CFD simulations and real-world experiments with a fixed-wing platform, showing reliable stabilization of sink rate, airspeed, and glide ratio under wind gusts and in presence of obstacles.
A fixed-wing UAV must hold airspeed, altitude, and heading references under wind, gusts, and turbulence, channels coupled so that correcting one can degrade another. Classical autopilots stabilize the airframe well but adapt poorly when a hard crosswind meets an aggressive turn, while reinforcement-learning (RL) policies acting directly on the surfaces concentrate exploration risk at the actuator interface. We place a learned supervisor above an unchanged autopilot rather than inside it: it selects a residual from a finite, bounded action set on the commanded airspeed, altitude, and heading; the modified reference is projected into an admissible command envelope before reaching the autopilot, which stays the only actuator-facing controller. What is new is how the residual is chosen. HJB residual scores candidates with a semi-discrete value-iteration critic in the spirit of the Hamilton-Jacobi-Bellman (HJB) equation, ranks them by a no-op-relative Hamiltonian advantage, and filters them through a control-Lyapunov- and control-barrier-inspired finite-action shield that always keeps a no-op fallback. On a shared 12-state runtime holding the plant, autopilot, and actuator model fixed, so the comparison is at the package level, HJB residual lowers mean RMS path-tracking error to 44.809 m, against 338.617 m for the baseline autopilot and 88.809 m for a tabular-Q residual, an 86.77% reduction over the baseline and 49.54% over Q-learning. The gain concentrates where the baseline fails worst and comes with a measured rise in airspeed error, so no method dominates every metric. We present this autopilot-preserving residual command-supervision design and benchmark with its trade-offs reported intact.
This study introduces a unified control framework for fixed-wing unmanned aerial vehicles (UAVs) fitted with a pan-tilt (PT) camera, intended to perform an end-to-end mission spanning from initial target detection to accurate terminal engagement. The proposed system employs a three-phase strategy: a vision-based target acquisition phase, an NMPC-based tracking phase, and a terminal guidance phase. During tracking, the framework uses an Unscented Kalman Filter (UKF) to fuse YOLO-based visual detections with inertial measurements, enabling robust target state estimation under unknown dynamics. To ensure reliable visual contact, we introduce a constraint-aware Nonlinear Model Predictive Control (NMPC) strategy that incorporates Control Barrier Functions (CBFs) to explicitly prevent UAV self-occlusion -- a common limitation in fixed-wing tracking. Upon satisfying terminal engagement conditions, the system seamlessly transitions control to a quaternion-based Biased Proportional Navigation Guidance (BPNG) law, enforcing precise impact angle constraints. High-fidelity simulations demonstrate that the framework achieves stable, robust tracking and accurate terminal interception while strictly respecting the vehicle's dynamic limits and camera field-of-view constraints.