underactuated robot control
Latest papers
8 papers1 paper in the last four weeks, with none the four weeks before. 0.0% of all new papers.
Robots with weak motors must ride their natural dynamics rather than fight them. We swing up a direct-drive planar two-link robot, whose motors deliver only about 6,% of its shoulder gravity torque, along its nonlinear normal modes, two-dimensional invariant manifolds consisting of periodic orbits. On a non-strict mode, injecting energy necessarily moves the state off the manifold, so pumping and stabilization compete for the same bounded torque. We split the input torque into a power-neutral steering component and a scalar pumping input, the only component that changes the energy. The allocation then becomes a linear program in two variables: maximize pumping subject to the torque limits and one control-Lyapunov constraint. The constraint uses the model-based rate of the error, so no stabilizing feedback gain is needed. Experiments in hardware show swing-ups along both modes and compare the allocation with summing-and-clipping and with prioritized stabilization.
Ground Reaction Force-Aware Model Predictive Control for Underactuated Upright Physical Assistance
Many rehabilitation robots execute prescribed motions using reactive tracking controllers that do not explicitly incorporate the user's instantaneous human-ground interaction. This paper presents Ground Reaction Force-Aware Model Predictive Control (GRF-MPC), a framework for upright physical assistance. By integrating live GRF and center of pressure (CoP) measurements directly into a human centroidal dynamics model, GRF-MPC formulates a real-time quadratic program (QP) that optimizes assistive forces and moments over a receding horizon. We deployed GRF-MPC on the Robotic Upright Stand Trainer (RobUST) in an underactuated 4-cable configuration and evaluated it against a fully actuated 8-cable Cartesian impedance baseline in nearly 300 trials across six healthy participants. Across tasks spanning impulsive perturbations, lunge trajectories, and voluntary limits of stability, GRF-MPC reduced peak planar center-of-mass (CoM) error by 19.6% during perturbations, lowered trajectory tracking error by 24.1%, required 28.7% less net mechanical work, and permitted a 45.9% greater normalized voluntary excursion area. The underlying QP solves in under 1 ms, comfortably enabling 100 Hz replanning and demonstrating that incorporating live human-ground interaction into predictive control yields stronger, more transparent physical assistance with half the actuators.
Spiking Neuromorphic Control for Periodic Orbits Stabilization in Underactuated Robots: A Greedy Lyapunov-Based Approach
This work investigates the use of event-based spiking controllers, implemented as spiking neural networks, for trajectory tracking in underactuated robots. Specifically, we address the problem of stabilizing a prescribed periodic orbit. It is well known that, by applying the method of transverse linearization to the robot dynamics in a neighborhood of a periodic trajectory, the dynamics can be approximately described by a linear time-varying system with periodic coefficients (a periodic LTV system). The problem of orbital stabilization can therefore be reduced to stabilizing the trivial solution of this LTV system. We show that a previously proposed Lyapunov-based greedy design, originally developed for LTI systems, can also be extended to the corresponding linearized transverse dynamics, which take the form of a periodic LTV system. This enables the construction of a feedback controller for orbital stabilization of the robot. The effectiveness of the proposed method is demonstrated on the trajectory stabilization problem for the butterfly robot.
Full Nonlinear Nonholonomic Dynamics and Motion Analysis of a 3-DoF Underactuated Spherical Rolling Robot
This paper presents a full nonlinear constrained dynamic model of MonoRollBot, a novel 3-DoF spherical rolling robot driven by a single motor, a lead-screw transmission, and a spring-coupled internal moving mass, together with motion analysis of its behavior. To the best of our knowledge, this is one of the first full nonlinear nonholonomic models reported for a mono-actuated, super-underactuated spherical rolling robot of this kind. Because rolling without slipping is nonholonomic, the dynamics are derived using the Lagrange--d'Alembert formulation, with the lead-screw relation imposed as a holonomic constraint and the rolling condition imposed in Pfaffian form. The formulation retains the complete generalized coordinates of shell translation, shell attitude, screw travel, nut rotation, and radial mass motion. Simulations and representative motion studies show qualitative agreement with prototype behavior and reveal how gravity, compliance, and inertia jointly shape the locomotion and motion capabilities of this strongly underactuated robot. The resulting model also provides a mechanically consistent basis for future state estimation and hybrid controller design for this nonholonomic mono-actuated rolling robot.
Optimal control of differentially flat underactuated planar robots in the perspective of oscillation mitigation
Underactuated robots are characterized by a larger number of degrees of freedom than actuators and if they are designed with a specific mass distribution, they can be controlled by means of differential flatness theory. This structural property enables the development of lightweight and cost-effective robotic systems with enhanced dexterity. However, a key challenge lies in managing the passive joints, whose control demands precise and comprehensive dynamic modeling of the system. To simplify dynamic models, particularly for low-speed trajectories, friction is often neglected. While this assumption simplifies analysis and control design, it introduces residual oscillations of the end-effector about the target position. In this paper, the possibility of using optimal control along with differential flatness control is investigated to improve the tracking of the planned trajectories. First, the study was carried out through formal analysis, and then, it was validated by means of numerical simulations. Results highlight that optimal control can be used to plan the flat variables considering different (quadratic) performance indices: control effort, i.e. motor torque, and potential energy of the considered underactuated joint. Moreover, the minimization of potential energy can be used to design motion laws that are robust against variation of the stiffness and damping of the underactuated joint, thus reducing oscillations in the case of stiffness/damping mismatch.
Underactuated multimodal jumping robot for extraterrestrial exploration
We present a rolling and jumping underactuated monopedal robot designed to explore multimodal locomotion on low-gravity bodies. It uses only two reaction wheels to control its spatial orientation with two controllers: a balancing controller which can aim the robot's jump direction on the ground, and an aerial reorientation controller which can aim the robot's leg for landing after flight. We demonstrate rolling, targeted jumping and landing, and self-righting using only three actuators total, keeping system size to 0.33m and 1.25kg. Simple switching between locomotion modes enables the system to deal with differing landscapes and environmental conditions.
Control Lyapunov Functions for Underactuated Soft Robots
Soft and soft-rigid hybrid robots are inherently underactuated and operate under tight actuator limits, making task-space control with stability guarantees challenging. Common nonlinear strategies for soft robots (e.g., those based on PD control) often rely on the assumption of full actuation with no actuator limits. This paper presents a general control framework for task-space regulation and tracking of underactuated soft robots under bounded inputs. The method enforces a rapidly exponentially stabilizing control Lyapunov function as a convex inequality constraint while simultaneously satisfying underactuated full-body dynamics and actuator bounds. We validate the approach in simulation on several platforms spanning increasing underactuation: a simple two link tendon-driven "finger", a trimmed helicoid manipulator, and a highly underactuated spiral robot. We compare against a number of baseline methods from the literature. Results show improved task-space accuracy and consistent Lyapunov convergence under input limits, achieving superior set-point and trajectory-tracking performance.
Soft Swing-up: Benchmarking Model-Based Optimal Control for Rigid-Soft Underactuated Systems
Continuum soft robots are inherently underactuated and subject to intrinsic input constraints, making dynamic control particularly challenging, especially in hybrid rigid-soft robots. While most existing methods focus on quasi-static behaviors, dynamic tasks such as swing-up require accurate exploitation of continuum dynamics. This has led to studies on simple low-order template systems that often fail to capture the complexity of real continuum deformations. Model-based optimal control offers a systematic solution; however, its application to rigid-soft robots is often limited by the computational cost and inaccuracy of numerical differentiation for high-dimensional models. Building on recent advances in the Geometric Variable Strain model that enable analytical derivatives, this work investigates three optimal control strategies for underactuated soft systems -- Direct Collocation, Differential Dynamic Programming, and Nonlinear Model Predictive Control -- to perform dynamic swing-up tasks. To address stiff continuum dynamics and constrained actuation, implicit integration schemes and warm-start strategies are employed to improve numerical robustness and computational efficiency. The methods are evaluated in simulation on three Rigid-Soft and high-order soft benchmark systems -- the Soft Cart-Pole, the Soft Pendubot, and the Soft Furuta Pendulum -- highlighting their performance and computational trade-offs.