Multimodal Sensor-Gated Mid-Air Launch and Vision-Based Recovery of a Child UAV on a Hovering Mothership Drone

Autonomous recovery of a small multirotor onto a hovering multirotor carrier differs from recovery onto ground or shipborne platforms because the recovery surface is itself an actively controlled, thrust-limited aerial vehicle. This paper presents a field-validated autonomy framework for a heterogeneous rover-mothership-child system executing rover supervision, mothership transit, child deployment and sortie, autonomous return, aerial recovery, and synchronized descent. The recovery stack combines jerk-bounded reference generation, disturbance-observer-augmented planar tracking, feasibility-aware vertical control, a discrete-time barrier-based safety filter for relative vertical geometry, and communication-aware carrier-state prediction. The contribution is the coordinated system-level integration of these methods for recovery onto a hovering multirotor and its full-scale outdoor validation. The framework is implemented on a PX4-ROS 2 architecture using RTK-enabled GNSS, IMU, and barometric fusion, with mothership-side 1D lidar used only as an auxiliary near-contact cue. RTK-fixed positioning was maintained throughout testing. Across 20 outdoor cooperative missions, 17 successfully completed deployment, sortie, and recovery, giving an observed mission success rate of 85%. For successful recoveries, mean terminal-alignment time was 6.3 s, mean planar alignment error at acceptance was 0.18 m, maximum terminal planar deviation was 0.32 m within a 0.40 m capture radius, and minimum logged relative vertical separation during coupled descent was 0.41 m. Mothership planar station-keeping RMS error was 0.25 m. The three unsuccessful trials occurred at different mission stages and are analyzed separately. Results demonstrate practical autonomous aerial recovery within the tested outdoor operating envelope.

Autonomous recovery of a micro unmanned aerial vehicle (UAV) onto a moving airborne carrier enables reusable deploy-mission-recover operation, but couples long-range rendezvous, close-range perception, carrier motion, aerodynamic interaction, and a discontinuous contact event. This paper presents an RTK-vision-guided reinforcement-learning framework in which a child UAV is physically transported by a larger carrier, takes off from the carrier while airborne, executes an independent sortie, returns to the carrier's current position, redocks, and subsequently descends with the carrier. Both vehicles carry RTK-GNSS, and the carrier continuously shares its navigation state with the child. Near the recovery deck, RTK remains active while a downward-facing camera with a fiducial marker detector provides marker-relative alignment cues. A proximal policy optimization (PPO) policy governing the terminal recovery phase is trained in a physics-based MuJoCo simulation environment with explicit sensor noise models, an aerodynamic disturbance surrogate, and marker-latency randomization, then transferred to hardware. PX4 retains low-level stabilization, and a deterministic safety gate authorizes descent independently of the learned policy. The PPO checkpoint achieves 99.55% success over 2,000 held-out randomized terminal episodes, compared with 78.4% for a tuned PD baseline under identical conditions, with a median planar terminal error of 6.62 cm. Across 14 outdoor trials, the full mission succeeds in 13 trials (92.9%), spanning both near-region recovery and recovery after the carrier translates away from the release point. The results demonstrate a complete autonomous aerial deployment-and-recovery cycle rather than an isolated landing maneuver, establishing a practical basis for reusable carrier-child operation in inspection, surveillance, and mobile-logistics applications.

Autonomous landing of Unmanned Aerial Vehicles on maritime vessels is challenging due to the coupled motion of the vehicle and landing platform in open-sea conditions. This paper presents a reinforcement-learning-based approach for autonomous multirotor landing on moving maritime platforms without requiring explicit platform-state observations or estimation during deployment. The proposed method uses multirotor state measurements together with local visual features, consisting of keypoints and associated descriptors extracted from the landing surface, to predict attitude and thrust commands. These commands are tracked by a conventional low-level controller. The policy is trained in simulation using synthetic keypoints with randomly generated normalized descriptors, enabling zero-shot deployment with different local feature extractors onboard the UAV. We evaluate the method in a realistic simulator and show that it outperforms a state-of-the-art Model Predictive Control baseline under platform motions corresponding to ''Very Rough'' sea conditions. Finally, we perform extensive real-world experiments, demonstrating autonomous onboard landing using two different local feature extractors. To the best of our knowledge, this is the first approach for agile multirotor landing on maritime platforms in turbulent waters that does not rely on an explicit platform-state during deployment.