Organizations: Faculty of Innovation Engineering, Macau University of Science and Technology, Macau, China · School of Aeronautical Science and Engineering, Beihang University, Beijing, China · Institute of Unmanned System, Beihang University, Beijing, China
A rudderless dual vectored-thrust flying wing combines vertical takeoff and landing with efficient for- ward flight in a compact tailless configuration. Without aerodynamic control surfaces, vectored thrust couples translation and pitch control. Therefore, generating dy- namically compatible trajectories remains an open chal- lenge. To address this challenge, this study proposes a trajectory generation method that jointly optimizes path geometry and timing. Trajectory inversion yields state and control histories that satisfy the coupled equations of motion. The optimization balances curvature-induced acceleration against aerodynamic support, lowering thrust- vectoring demand while retaining the defining maneuver features. Representative looping and rolling sequences are tracked in closed-loop simulations. These results provide a basis for planning autonomous aerobatic maneuvers with rudderless vectored-thrust aircraft.
Figures & tables
Fig. 1: Aircraft configuration, body axes and dual vectored-thrust actuation.
Fig. 2: S-shaped climb before and after joint geometry and timing optimization. The endpoint motion and duration are fixed.
Fig. 3: Cloverleaf with four quarter rolls (F1). Dashed curves show the original geometry, and solid curves show the closed-loop path. Enlarged aircraft use actual attitudes and applied vectoring commands at equal arc-length intervals. Numbers indicate flight order.
Fig. 4: Reverse half-Cuban and half-Cuban sequence (F4), using the same conventions as Fig. 3 .
Fig. 5: Straight rolling sequence (F8): continuous roll, four-point roll and knife-edge hold.
Case
nmax
Ωmax
ep,max (mm)
γR,max (deg)
F1
1.34
0.72
1.3
0.041
F4
2.94
0.70
6.7
0.77
F8
1.01
0.58
4.0
0.90
TABLE I: Closed-loop response of the illustrated sequences.
Fig. 6: F1 closed-loop response. In (a,b), solid curves are actual states and dashed curves are references. Quaternion components (w,x,y,z) use blue, orange, yellow and purple; body rates (x,y,z) use blue, orange and yellow. Applied input channels 1 and 2 use blue and orange.
Fig. 7: F4 closed-loop response. In (a,b), solid curves are actual states and dashed curves are references. Quaternion components (w,x,y,z) use blue, orange, yellow and purple; body rates (x,y,z) use blue, orange and yellow. Applied input channels 1 and 2 use blue and orange.
Fig. 8: F8 closed-loop response. In (a,b), solid curves are actual states and dashed curves are references. Quaternion components (w,x,y,z) use blue, orange, yellow and purple; body rates (x,y,z) use blue, orange and yellow. Applied input channels 1 and 2 use blue and orange.
Trajectory optimization computes motion or control sequences that minimize costs while satisfying system dynamics, safety limits, and task constraints.
Robotics and Mechatronics lab, Faculty of Electrical Engineering, Mathematics & Computer Science, University of Twente, Enschede, The Netherlands. · Department of Computer, Control and Management Engineering, Sapienza University of Rome, 00185 Rome, Italy.