This paper analyzes the cooperative transportation of a payload suspended from two drones in which, instead of being attached to two independent ropes, the payload is allowed to slide along a single rope connecting both UAVs. First, a planar nondimensional dynamical model of the sliding motion with viscous friction is presented. Then, considering stationary drones, this configuration is compared with a fixed payload with the same total rope length, both at equilibrium and under disturbances. The analytical results show that the sliding payload equalizes the tension in both rope segments for any relative position of the drones, so that no rope loses tension at equilibrium; it doubles the region reachable by the payload and, except for low friction combined with a large drone separation, it enlarges the set of admissible disturbances. Finally, a dynamic simulation also shows that under realistic gusty wind profiles, the average tension imbalance between the drones is reduced with respect to the fixed-payload solution.
Figures & tables
Fig. 1: Two-drone payload transportation: fixed-payload configuration with two ropes (left) and sliding-payload configuration with a single rope (right).
Fig. 2: Sliding-payload system in the X – Z plane: a payload of mass m slides along a rope of length L held by two drones, dividing it into segments ℓ and L−ℓ . The payload is located on the gray ellipse whose foci are situated at the drones. The payload is subject to its weight mg , the rope tensions T1 and T2 , and a disturbance force Fp=[Fpx,Fpz]⊤ .
Fig. 3: Steady-state analysis of the sliding payload (top row) and fixed payload (bottom row) configurations. Lengths and tensions are normalized. The solid semicircle marks the maximum drone separation ( d=L ). The dotted circles delimit the region in which one of the ropes loses tension in that case. Two positions of drone 2 are highlighted: position 1, (0.35,0.5) , in red, and position 2, (0.6,−0.2) , in black. In the drone layout, the region reachable by the payload is in gray (at position 1 in the fixed-payload case, rope 1 becomes slack, dashed line, and the payload hangs vertically from drone 2, dark red, instead of occupying the position it would have with both ropes taut, light red).
Fig. 4: Response to a step disturbance Fˉp=[0.5,0]⊤ at τ=0 for Δxˉd=0.5 and Δzˉd=0 , for both configurations under different friction coefficients bˉ . Top: time trajectory of ℓˉ . Bottom: evolution of the rope tensions Tˉ1 and Tˉ2 .
Fig. 5: Admissible disturbance regions for 3 different geometric configurations ( Δzˉd=0 ). Each is evaluated using its critical friction, twice that value, and half that value.
Fig. 6: Response to a gusty wind. First: wind force Fˉpx (blue) and Fˉpz (red). Second: payload position ℓˉ along the rope. Third: rope tensions Tˉ1 (blue) and Tˉ2 (red) for the fixed payload (dotted) and the sliding payload with bˉ=bˉcrit/2 , bˉcrit and 2bˉcrit (solid, dark to light). Fourth: Power consumption proxy T12+Tˉ22 for the four cases.
Department of Informatics, Bioengineering, Robotics and Systems Engineering, Università degli Studi di Genova, Via all’Opera Pia 13, 16145, Genoa, Italy